Рация гранит 2p-24 инструкция

рация гранит 2p-24 инструкция
The programming cable is intended to be used with a computer RS-232 port for programming radios and other devices. Check the component correspondence with the schematic diagram. Most radios are put in programming (cloning) mode automatically. Конструктивные особенности и используемые материалы обеспечивают ударопрочность и влагозщищенность.


Otherwise TxD to RxD interference will result in programming failure. It is important for some KENWOOD radios. It is convenient to use an additional connector to attach particular radio jacks to the programming cable. DB9 is recommended as a highly reliable one. Закажите термобелье уже сейчас – и воспользуйтесь бонусами Удобнее забирать заказ на почте? The radio should be programmed with slow computers (recommended processor rate 166 MHz or less) under MS DOS. Valery UA6LPG has designed a connector to Russian Granit-202 radios. The battery of a portable radio must be charged completely. A mobile radio must be powered with an appropriate power supply. 6. Consider the specific features of the radio being programmed.

Oleg EX8MLT has proposed HYT TC-500 radios connector. It is different from KENWOOD portables connector which is used for other HYT radios. The jack flanges should be ground off till 5 mm in diameter. Some radios are put in programming (cloning) mode manually by pressing a specific set of buttons while turning on. The main goal of this cable schematics is the invertion of signal levels. Cable connection to KENWOOD portable radios has a specific feature. Лезвия — 100мм Слабое звено Смазка аэрозольная силиконовая Смазка Литол — 24 Смазка Литол — 24 8,5кг Смазка Солидол Смазка Солидол 9 кг Смазка графитная Смеситель для душа Смеситель для мойки Смеситель для раковины Смола эпоксидная с отверд.

Похожие записи:

Comments are closed, but trackbacks and pingbacks are open.